The V2 version of the 3racing d5s frame is updated, and shims are added to slightly change the default settings of the front suspension and adjust the geometry.
Update to d5s V2 version
Package unpacking drawing:
D5S 车架包含漂移轮胎,马达齿25T,大齿83T,内齿比3.0
包装里赠送新款贴纸
In order to match the new setting, the holes on the bottom plate and the front hydraulic frame will be increased and slightly adjusted.
The position of the oil pressure rack update hole is changed from the horizontal hole to the vertical hole. The default installation hole is dominated and does not change
Add gasket
M3x6x2.5mm spacer x 4pcs (3RAC-WF325)
M3x6x1mm spacer x 4pcs (3RAC-WF310)
球头安装位置改变为竖直向前孔位
D5S 车架可单购垫片升级包(垫片)升级为V2版本.
Upgrade package content:
V2 carbon fiber three piece set
Add gasket use position:
The design concept of the D5S makes drift easier, becoming your first drift RC
Low center of gravity design, rear wheel drive rear mounted motor, IFS reclining shock absorber;
Easy to install interior, adjustable front and rear width 190-210, wheelbase 260mm
The front bumper is widened with full glass fiber to enhance the position of the steering gear
The KPI system has an extremely large steering angle, sealed differential, gear differential, 3.0 gear ratio, and is equipped with a magnetic car shell column
Multiple disruptive improvements surprise you, continuing the excellent design and high cost-effectiveness of 3RACING in the past
The car shell can be either a 190 wide body or a 195-200mm drift car shell
随车附送工具
