New EWS IMMO Simulator with Cable Without Cable Option for BWM Vehicle EWS2 EWS 3.2 Emulator Immobilizer Programmer High Quality
Emulator E34 E36 E38 E39 E46 For BM EWS2 EWS3.2 is shipped with JUMPER 1 shorted.
1.For testing purposes ISN 0579 is stored by default.
2.There are NO any counters or car starts limited. You can change and store new ISN without any limitations.
3.For testing purposes ISN 0579 is stored by default.
Emulator E34 E36 E38 E39 E46 For EWS2 EWS3.2
Top 2 Reasons To Get EWS2 EWS3.2 Emulator
1. There are NO any counters or car starts limited. You can change and store new ISN without any limitations.
2. Emulator is shipped with JUMPER 1 shorted. For testing purposes ISN 0579 is stored by default.
Notice: In case of EWS3.2 similar procedure is used, only difference is that that it is NOT connected directly to diagnostic K-line.
Connection Picture:
Installation:
1. Remove original EWS2 control unit, find +12v ACC, GND, K-line wires, attach emulator. Emulator must be in service mode: JUMPER 1 shorted.
![](http://ae01.alicdn.com/kf/HTB1ZsxFSVXXXXamapXXq6xXFXXXS.jpg?width=592&height=300&size=32154&hash=33046)
2. Connect ANY K-line diagnostic adapter to vehicle diagnostic connector and launch EMULATOR CONFIGURATION UTILITY:
3. Choose COM port, write in desired ISN number, press button Store. Or –
4. For some ECU s it is possible to read ISN number directly from engine control unit. In this case select option ECU xxxxx , press Read. Software will try to read ISN. If successful, choose option EWS emulator and press button Store to save ISN number into emulator.
5. Disconnect emulator from K-line, remove JUMPER 1 and connect K output from emulator to DME(DDE) EWS line.
6. Don t forget to short two starter relay wires (EWS connector)!
7. Car is ready to start.
EWS2 EWS3 IMMO
This device can emulate for BMW EWS 2 and EWS 3.2 immobilizer (EWS module) in cases when original system restore is impossible (faulty EWS, lost or damaged transponders, continuous problems with rolling codes etc.).
1. Remove original EWS2 control unit, find +12v ACC, GND, K-line
2. Disconnect emulator from K-line, connect K output from emulator toDME(DDE) EWS line.
3. Don t forget to short two starter relay wires (EWS connector)!
4. Car is ready to start.