Product Description:
This product is a blind area assistance system, which monitors the closing objects in the neighbor lane within a range of 6 to 12 meters by two 24 GHz millimeter-wave radars mounted on the rear bumper of the car. When the moving object enters the blind area, the LED light will be on to alert the driver. At the sane time, when the steering is also turned on , the system works in the lane change assistant mode. The LED light will flash rapidly and a sound will be given three times to alert the driver being careful to change a lane. After the ACC is powered on, the system can immediately enter the working state after the environmental adaptation test. When the car is turned off, the radar stops working.
Features:
1. Strong anti-interference capability.
2. Long detecting distance.
3. Intelligent algorithm,accurately judge whether the target is dangerous.
4. When the system is on, the system would start detecting objects in the blind area behind the vehicle 10 meters.
5. When moving objects get closer and faster than our own cars, LED and buzzer will give a warning.
6. This item fits for most DC12v sedan, compact, SUV, MPVs, pickup etc.
Warning:
This system is only auxiliary during the driving. Please operate according to the actual traffic conditions.
Specifications:
ADAS: Advanced Driving Assistance System
Working Voltage: DC 9~16V
Working Current: 190MA±5MA
Working Temperature: -40℃~+85℃
Static current: ≤1mA
Working frequency: 24GHZ~24.25GHZ
Speed range: ≤120KM/h
Detect range: Rear side 6 to12 meters
Warning: Buzzer and LED light
Brand: SPY
Packing list:
Installation Method:
1. After the bumper is removed, find a proper position for the probe module, Which is located on the arc surface of the bumper.
2. Install the bracket and lock it tightly. The radar module is tighted a little bit with the supplied screw for further adjusting the angle(lock tightly later on).
3. Set A reference line, which is in parallel to the rear of the car.
4. Check the mounted angle like the picture shown below and then lock.
5. Installation
6. Diagram
Function Verification:
Warning: The ACC cable must be controlled by the ignition switch of the car.
