CPVAN wireless Infrared Motion Detector Alarm for Home Security protection PIR motion sensor with remote control

Low battery alarm: When the battery is low, the motion sensor emits a short tick every few minutes to remind you to change the battery.

Safe design: CPVAN alarm system motion sensor has advanced infrared detection technology with a range of 5-8 metres. In addition, the CPVAN mobile alarm system has a 125 DB siren that has a range of up to 100 metres in open areas. It can deter both intruders and alert you in time. So you and your family are safe at all times.

Installation is very simple: CPVAN motion sensor alarm comes with an installation tool with double-sided tape and screws, you can choose whether you want to punch holes for installation according to your actual needs.

Remote control: the CPVAN motion sensor alarm can be paired with a remote control (included) to allow remote control. You no longer have to worry about not being able to operate the motion sensor alarm immediately because it is mounted too high and too far away. Alternatively, you can control multiple motion detector alarms simultaneously with a single remote control or a motion sensor alarm with multiple remote controls.

More user-friendly power supply modes: CPVAN motion sensor alarm has both a wireless and wired power supply mode. The wireless mode is powered by 3 AA batteries (not included); the wired mode is powered by a USB cable (not included) + 5V charger (not included). You can choose the most suitable power supply mode according to your actual needs.

Alarm Battery：3 AA batteries (not included)

Remote Control：CR2032

Door Sensor:23A 12V

Q：How long does it take for the PIR motion detector alarm to be set up?

A : About 30 seconds or so.

Q : Once the home alarm system has been triggered, does it switch off automatically after a certain time?

A : The system has a door chime and an alarm function. The door chime only sounds once, the alarm continues to sound and you must use the remote control or approach the alarm to switch it off.

Q : When the button is pressed, the light on the remote control lights up, but the device does not respond.

A : The battery is exhausted. Insert a new battery.

 Q ： How do you have to get out of the way when you switch on the garage alarm?

 A : fter you have activated the motion detector. It is not triggered immediately and you have 3 seconds to leave the alarm area. You can also activate/deactivate the alarm from outside using the remote control.

Tip: Alarm Battery：3 AA batteries (not included)