The third step, the flight control panel mounted on the distributor plate with 3M adhesive power transfer signal line sequentially inserted in the flight control, so that the installation is complete, the following can be directly flight control parameter adjustment, and this wiring is simple, simple wiring.
The first step: the first sub-plate with nylon screws on the bottom of the fuselage
The second step, after the power transfer power cord soldered XT90 male, according to the axis or six-axis inserted in the order of sub-board power, the same power transfer signal lines are sequentially inserted in the distributor plate, this must Note the installation sequence.
The third step, the flight control panel mounted on the distributor plate with 3M adhesive power transfer signal line sequentially inserted in the flight control, so that the installation is complete, the following can be directly flight control parameter adjustment, and this wiring is simple, simple wiring.
